LDT—Linear Displacement Transducer
Model: S-LDT
The S-LDT provides a simple measuring device for measuring displacements up to 50mm.
This device will work on standard wheatstone bridge instrumentation using a 0-2mV/V range, or, there is an optional 0-5-5.5 analogue output option.
The S-LDT is produced from stainless steel material.
Typical Specification
| Parameter | Value | Units |
|---|---|---|
| Nominal Displacement | 5, 10, 25, 50 | mm |
| Rated Output | 2.0 nominal | mV/V |
| Linearity & Hysteresis | 0.1% | ±% of FS |
| Zero Return after 30 minutes | 0.1 | ±% of Applied Load |
| Zero Balance | 1.0 | ±% of Rated Output |
|
Temp. Range: Operating Temp. Range: Compensated |
-10 to +70 -10 to +70 |
°C |
|
Temp. Effect: On Output Temp. Effect: On zero |
0.005 0.01 |
±of Rated Output/°C ±of Rated Output/°C |
| Safe Overload | NA | % of Rated Capacity |
| Ultimate Overload | NA | % of Rated Capacity |
|
Excitation: Recommended Excitation: Maximum |
10 18 |
Volts AC or DC |
| Input Resistance | 350 nom | ohm |
| Outut Resistance | 350 nom | ohm |
| Insulation Resistance | >2 | GΩ at 50VDC |
| Deflection at Rated Capacity | NA | mm |
| Weight (approximate) | NA | kg |
| Construction | Stainless Steel | |
| Environmental Protection | IP40 | |
| Cable | 3m 4 core screened |
Outline Dimensions in millimeters
NOTE: If the dimensions or specification do not suit, PCM have an in-house design and build service that should satisfy your requirements.
Wiring Detail
Features
- Displacements 5, 10, 25, 50mm
- Strain gauge based—wheatstone bridge
- Nominal Sensitivity 2mV/V
- Linearity ±0.1% FS
Applications
- Test Machines
- Process Control
- R&D projects
