Load Cell - Amplifiers
Amplifiers are electronics that do not have displays. They transform a load cell signal (mV/V) to another type of signal ie: analogue (e.g.: mA, V) or digital output (e.g.: RS232, RS485).
The load cell and amplifier will require calibrating together for the system to work correctly. This is done by applying a known force to the load cell and the amplifier gain to be set.
If you would prefer to discuss your application with an engineer whilst studying the website, please do not hesitate to contact us on +44 (0) 1926 864444.
Load Cell - Amplifiers
-
Strain Gauge or Load Cell Embedded Analogue Amplifier View PDF
Standardised mounting hole for faster & easier installation.
Reduced height of just 7.6mm.
Robust design, reverse polarity & short circuit protected. -
DCell- Digital Strain Gauge or Load Cell Embedded Digitiser Module. View PDF
New Generation Extremely High Performance & Low Cost.
High speed to 500 Readings/Sec.
Extreme Noise Immunity 5 x heavy industrial level. -
DSCUSB- USB Strain Gauge or Load Cell Digitiser Module View PDF
Quick and easy connectivity via USB.
High speed to 500 readings/second.
MODBUS RTU and ASCII protocols available. -
Strain Gauge/Load Cell Amplifier/Signal Conditioner View PDF
User-selectable analogue output ±10V, ±5V, 0-10V, 0-5V, 0-20mA, 4-20mA.
230/110VAC or 18-24Vdc power supply.
IP65 ABS field case with cable glands. -
LCA15, LCA15F & LCB- Weighing Amplifier/Digitiser View PDF
4-20mA and 0-10V outputs.
Simple one pass Auto Calibration.
IP65 surface mounting case. -
Rack Mounted Amplifier/Digitiser View PDF
Offers both 4 to 20mA and 0 to 10 volt analogue outputs.
Auto Tare and Peak Hold.
High accuracy/low drift. -
UAB- Universal Amplifier/Digitiser View PDF
Voltage and current analogue outputs available.
Suitable or summation of analogue signals.
Wall, DIN Rail and Rack mounted amplifiers are available.