Clamp-On Rope Tension Sensor
Model: T-CORTS
The T-CORTS is a simple transducer that clamps onto the rope at the dead end on a crane system.
It is mainly used for overload and slack rope detection when coupled with an LCA15 amplifier.
If the dimensions or specifications do not satisfy your application, then please contact PCM and their in-house design and build service may be able to supply to your requirements.
Typical Specification
| Parameter | Value | Units |
|---|---|---|
| Diameter Sizes | 8-14, 15-20, 21-30, 31-40 | mm |
| Rated Output | 0.7-1.5 nominal | mV/V |
| Linearity & non repeatability | 5* | ±% of Rated Output |
| Zero Return after 30 minutes | 0.05 | ±% of Applied Load |
| Zero Balance | 1.5 | ±mV/V |
|
Temp. Range: Operating Temp. Range: Compensated |
-30 to +80 -10 to +60 |
°C |
|
Temp. Effect: On Output Temp. Effect: On zero |
0.1 0.02 |
±% of Applied Load/°C ±% of Rated Load/°C |
| Safe Overload | 200 | % of Rated Capacity |
| Ultimate Overload | 500 | % of Rated Capacity |
|
Excitation: Recommended Excitation: Maximum |
10 15 |
Volts AC or DC |
| Input Impedance | 350 nominal | ohm |
| Output Impedance | 350 nominal | ohm |
| Insulation Resistance | >2 | GΩ at 50VDC |
| Deflection at Rated Capacity | N/A | mm |
| Weight (approximate) | N/A | kg |
| Construction | Plated Alloy Steel | |
| Environmental Protection | IP65 | |
| Cable | 5m 4 core scr |
Outline Dimensions in millimeters
NOTE: If the dimensions or specification do not suit, PCM have an in-house design and build service that should satisfy your requirements.
Wiring Detail
Loading Mode
Modifications reserved. All details describe our products in general form only. PCM assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sales and/or use of PCM products including liability or warranties relating to fitness for a particular purpose.
Features
- Diameter Sizes 8mm – 40mm
- Sealed to IP65
- Custom build dimensions available
Applications
- Overload and slack rope protection
- Gantry / overhead cranes
