TCE-Bi-Directional S Type Load Cell

Products & Services

TCE-Bi-Directional S Type Load Cell

Model: BD-ST-TCE

The BD-ST-TCE provides a simple measuring device for tension and compression measurement.

The TCE is produced from stainless steel and is a fully welded assembly.

The TCE load cell has been designed for test rig applications where static and dynamic measurement is required.

The indicator has a 7 segment display with a character height of 13mm.

Typical Specification

PARAMETER	VALUE	UNITS
Capacities Range	0.. 350, 500 0..1, 2.5, 5, 7.5, 10, 20	kg Te
Rated Output	2.0 ±0.002%	mV/V
Linearity & non repeatability	0.05	±% of Rated Output
Zero Return after 30 minutes	0.05	±% of Applied Load
Zero Balance	1.0	±% of Rated Output
Temp. Range: Operating Temp. Range: Compensated	-20 to +70 -10 to +40	°C
Temp. Effect: On Output Temp. Effect: On zero	0.03 0.01	±% of Full Scale ±% of Full Scale
Safe Overload	150	% of Rated Capacity
Ultimate Overload	300	% of Rated Capacity
Excitation: Recommended Excitation: Maximum	10 18	Volts AC or DC
Input Impedance	420 nominal	ohm
Outut Impedance	350 nominal
Insulation Resistance	>5	GΩ at 50VDC
Deflection at Rated Capacity	NA	mm
Weight (approximate)	NA	kg
Construction	Stainless Steel
Environmental Protection	IP67
Cable	5m 4 core scr

Outline Dimensions in millimeters

Dimensions

NOTE: If the dimensions or specification do not suit, PCM have an in-house design and build service that should satisfy your requirements.

Wiring Detail

Loading Mode

Modifications reserved. All details describe our products in general form only. PCM assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sales and/or use of PCM products including liability or warranties relating to fitness for a particular purpose.

PCM - The Load Cell and Strain Gauging Specialists

PCM

Products & Services