S-EBS- Eye Bolt Sensor
Model: S-EBS
The S-EBS is an eye bolt or rod end with a full wheatstone bridge bonded to it.
Therefore transforming the bolt into a load cell.
The performance will depend on the quality of the bolt’s performance. Either PCM or the customer can supply the bolt.
The installation can be either externally bonded (as the above picture), or internally bonded.
The build specification will be established during the quotation stage as there are plenty of options available.
Typical Specification
| PARAMETER | VALUE | UNITS |
|---|---|---|
| Capacity | To suit the bolt size | µε |
| Rated Output | Dependant on bolt size and diameter | mV/V |
| Linearity & non repeatability | Typically 0.25% depending on bolt quality | ±% of Rated Output |
| Zero Return after 30 minutes | 0.15 | ±% of Applied Load |
| Zero Balance | 1.5 | ±% of Rated Output |
| Temp. Range: Operating Temp. Range: Compensated |
-30 to +80 | °C |
| Temp. Effect: On zero | 0.2 | µV/V/°C |
| Safe Overload | 150 | % of Rated Capacity |
| Ultimate Overload | 300 | % of Rated Capacity |
| Excitation: Recommended Excitation: Maximum |
10 15 |
Volts AC or DC |
| Input Impedance | 120 - 350 nominal | ohm |
| Output Impedance | 120 - 350 nominal | ohm |
| Insulation Resistance | >2 | GΩ at 50VDC |
| Deflection at Rated Capacity | NA | mm |
| Weight (approximate) | NA | kg |
| Construction | Steel—depending on bolt | |
| Environmental Protection | IP67 | |
| Cable | Optional |
Features
- Capacities 500-1000Kg
- Sealed to IP65
- Accuracy 1%RO
- Custom Build dimensions available
Applications
- General purpose use
- Hoppers and small silos
- Industrial Platforms
- Test Rigs
