CNC-Compression Load Cell

Products & Services

CNC-Compression Load Cell

Model: C-CNC

The CNC is a heavy duty low profile column design load cell produced from plated steel. If the capacities or dimensions do not suit your requirements, PCM's in-house design and build service may be able to satisfy your requirements.

The units are supplied with calibration certificates using a BS EN ISO7500-1 test machine traceable to national standards.

Typical Specification

Linearity & non repeatability

PARAMETER	VALUE	UNITS
Capacities Range	0.. 75, 100, 200, 300, 400	Te
Rated Output	2.0 nom	mV/V
0.5% (*1-1.5%)	±% of Full Scale
Zero Return after 30 minutes	0.05	±% of Applied Load
Zero Balance	1.0	±% of Full Scale
Temp. Range: Operating Temp. Range: Compensated	-30 to +80 -10 to +70	°C
Temp. Effect: On Output Temp. Effect: On zero	0.1 0.02	±% of Full Scale ±% of Full Scale
Safe Overload	150	% of Rated Capacity
Ultimate Overload	300	% of Rated Capacity
Excitation: Recommended Excitation: Maximum	10 15	Volts AC or DC
Input Impedance	760 nominal	ohm
Output Impedance	700 nominal	ohm
Insulation Resistance	>2	GΩ at 50VDC
Deflection at Rated Capacity	NA	mm
Weight (approximate)	NA	kg
Construction	Plated Alloy Steel
Environmental Protection	IP65
Cable	5m 4 core scr

Outline Dimensions in millimeters

Dimensions

NOTE: If the dimensions or specification do not suit, PCM have an in-house design and build service that should satisfy your requirements.

Wiring Detail

Loading Mode

Modifications reserved. All details describe our products in general form only. PCM assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sales and/or use of PCM products including liability or warranties relating to fitness for a particular purpose.

PCM - The Load Cell and Strain Gauging Specialists

PCM

Products & Services