C2S Diaphragm Load Cell
Model: C2S
Low profile load cell produced from stainless steel. The C2S is produced for long term stability and is completely laser welded, suitable for dynamic applications. This is a standard design load cell.
Typical Specification
| PARAMETER | VALUE | UNITS |
|---|---|---|
| Capacities Range | 0.. 100, 250, 500 | Kg |
| Capacities Range | 0.. 1, 2.5, 5, 7.5, 10, 20, 30, 50, 75, 100 | Te |
| Rated Output | 2.0 nom | mV/V |
| Linearity & non repeatability | 0.05 | ±% of Rated Output |
| Zero Return after 30 minutes | 0.025 | ±% of Applied Load |
| Zero Balance | 1.0 | ±% of Rated Output |
| Temp. Range: Operating Temp. Range: Compensated |
-20 to +70 -10 to +40 |
°C |
| Temp. Effect: On Output Temp. Effect: On zero |
0.0015 0.0015 |
±% of Rated Output/°C ±% of Rated Load/°C |
| Safe Overload | 150 | % of Rated Capacity |
| Ultimate Overload | 300 | % of Rated Capacity |
| Excitation: Recommended Excitation: Maximum |
10 18 |
Volts AC or DC |
| Input Impedance | 700 nominal | ohm |
| Output Impedance | 700 nominal | ohm |
| Insulation Resistance | >5 | GΩ at 50VDC |
| Deflection at Rated Capacity | NA | mm |
| Weight (approximate) | 3.4 | kg |
| Construction | Stainless Steel | |
| Environmental Protection | IP68 | |
| Cable | 5m PVC core scr |
Outline Dimensions in millimeters
NOTE: If the dimensions or specification do not suit, PCM have an in-house design and build service that should satisfy your requirements.
Wiring Detail
Loading Mode
Modifications reserved. All details describe our products in general form only. PCM assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sales and/or use of PCM products including liability or warranties relating to fitness for a particular purpose.
Features
- Capacities 0..100-0..100Te
- Sealed to IP68
- Compression use
- Single wheatstone bridge
Applications
- Test machines
- Mis-aligned loading applications
- Restricted height constraints
- Virtually all industries
