Diaphragm-Compression Load Cell

Products & Services

Diaphragm-Compression Load Cell

Model: C-DIA

The C-DIA is a diaphragm design load cell produced from either aluminium or stainless steel depending on the capacity. Its low profile design allows it to be used in restricted height applications. If the capacities or dimensions do not suit your requirement, PCM's in house design and build service may be able to satisfy your requirements.

TThe units are supplied with calibration certificates using a BS EN ISO 7500-1 test machine traceable to national standards

Typical Specification

PARAMETER	VALUE	UNITS
Capacities Range	0.. 500, 1000	Kg
Rated Output	2.0 nom	mV/V
Linearity & non repeatability	0.5 - 1.0	±% of Full Scale
Zero Return after 30 minutes	0.05	±% of Applied Load
Zero Balance	1.0	±% of Full Scale
Temp. Range: Operating Temp. Range: Compensated	-30 to +80 -10 to +70	°C
Temp. Effect: On Output Temp. Effect: On zero	0.1 0.02	±% of Applied Load/°C ±% of Rated Output/°C
Safe Overload	150	% of Rated Capacity
Ultimate Overload	300	% of Rated Capacity
Excitation: Recommended Excitation: Maximum	10 15	Volts AC or DC
Input Impedance	400 nominal	ohm
Output Impedance	350 nominal	ohm
Insulation Resistance	>2	GΩ at 50VDC
Deflection at Rated Capacity	NA	mm
Weight (approximate)	NA	kg
Construction	500Stainless Steel
Environmental Protection	IP67
Cable	3m 4 core scr

Outline Dimensions in millimeters

Dimensions

NOTE: If the dimensions or specification do not suit, PCM have an in-house design and build service that should satisfy your requirements.

Wiring Detail

Loading Mode

Modifications reserved. All details describe our products in general form only. PCM assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sales and/or use of PCM products including liability or warranties relating to fitness for a particular purpose.

PCM - The Load Cell and Strain Gauging Specialists

PCM

Products & Services