250-Miniature Load Cell Model: BD-250-MS

Products & Services

250-Miniature Load CellModel: BD-250-MS

Model: BD-250-MS

The 250 Miniature design load cell is produced from stainless steel.

Its low profile design allows it to be used in restricted height applications.

If the capacities or dimensions do not suit your requirement, PCM's in house design and build service may be able to satisfy your requirements.

Typical Specification

PARAMETER	VALUE	UNITS
Capacities Range	0.. 100, 200, 400, 800	N
Rated Output	1.6 nominal	mV/V
Linearity & non repeatability	0.5	±% of Rated Load
Hysterisis	0.5	±% of Rated Load
Repeatability	0.1	±% of Rated Load
Zero Return after 30 minutes	0.01	±% of Applied Load
Zero Balance	4.0	±% of Rated Output
Temp. Range: Operating Temp. Range: Compensated	-30 to +80 -10 to +50	°C
Temp. Effect: On Output Temp. Effect: On zero	0.005 0.03	±% of Full Scale ±% of Full Scale
Safe Overload	150	% of Rated Capacity
Ultimate Overload	200	% of Rated Capacity
Excitation: Recommended Excitation: Maximum	5 10	Volts AC or DC
Input Impedance	350 nominal	ohm
Output Impedance	350 nominal	ohm
Insulation Resistance	>5	GΩ at 50VDC
Deflection at Rated Capacity	>0.5	mm
Weight (approximate)	NA	kg
Construction	Stainless Steel
Environmental Protection	IP65
Cable	2m 4 core scr	screen not connected to load cell

Outline Dimensions in millimeters

Dimensions

NOTE: If the dimensions or specification do not suit, PCM have an in-house design and build service that should satisfy your requirements.

Wiring Detail

Loading Mode

Modifications reserved. All details describe our products in general form only. PCM assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sales and/or use of PCM products including liability or warranties relating to fitness for a particular purpose.

PCM - The Load Cell and Strain Gauging Specialists

PCM

Products & Services