Load Cell Simulator
If you have the requirement to set up an indicator or amplifier without the ability of applying a known force / load, then this can solve your problem.
Once you know the load cell’s output which is taken from the calibration sheet, connect the simulator to the instrumentation, the operator can dial this output onto the simulator and the start the calibration.
Please note that it is always preferred to apply a physical known force to the load cell.
If you would prefer to discuss your load cell application with an engineer whilst studying the website, please do not hesitate to contact us on +44 (0) 1926 864444.
Load Cell Simulator
-
Type 2130A- Analogue Load Cell Calibration Simulator View PDF
Rapid and accurate calibration of strain gauge instrumentation.
No drift, either short or long term.
Switch Selection of five commonly used strain gauge resistance values from 120 to 1000Ω. -
Type SG- PA8201- Digital Load Cell Calibration Simulator View PDF
Useful for scaling and system testing.
Numerical and bargraph display o output level.
Load Cell resistance DIP switch selectable as 350, 700, 1000 or 2000Ω.